Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
00 00 ... Engine Oil Service
Carry out oil service at normal operating temperature.
First replace oil filter, then change oil.
Clean sealing surfaces.
Add engine oil in accordance with inspection sheet.
Run engine at idle until oil level and oil pressure warning lamps go out.
Check oil filter housing and oil drain plug for leaks.
Switch off engine, check oil level, correct if necessary (car must be on a horizontal level surface).
Remove any oil traces.
Fill out oil documentation.
Repair instructions:
For details on how to proceed, refer to 00 00 610 ENGINE OIL SERVICE (N62) .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.