Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4038 (STEERING AND WHEEL ALIGNMENT - REPAIR - F12)ELECTRONIC CHASSIS ALIGNMENT32 00... KDS DATA STATUSES
2013 Mini Cooper Countryman, Standard Trans
32 00... KDS data statuses
2013 Mini Cooper Countryman, Standard TransSECTION 32 00... KDS data statuses
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
Setpoint values for wheel alignment are not published in ISTA.
See:
- www.bmwbroup-wep.com
- Workshop Equipment catalogue:
- Select Wheel alignment
- Select KDS nominal values
- e.g. select "Beissbarth KDS update", copy data
Or:
- Aftersales Assistance Portal (ASAP)
- Profile: Select Service/Technology
- Select Workshop equipment
- Select Start BMW
- Select Workshop equipment catalogue
- Select Wheel alignment
- Select KDS nominal values
- e.g. select "Beissbarth KDS update", copy data
We recommend that the data records are updated on a regular basis.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.