SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3987 (GENERAL ELECTRICAL SYSTEM - REPAIR)PLUG CONNECTION, TERMINAL, POWER DISTRIBUTION BOX61 13... OPENING PLUG HOUSINGS AND REMOVING CONTACTS OF DIFFERENT PLUG SYSTEMS61 13... CIRCULAR CONNECTOR, 7-PIN, 8-PIN, SYSTEM D2.5
2013 Mini Cooper Countryman, Standard Trans

61 13... Circular connector, 7-pin, 8-pin, system D2.5

2013 Mini Cooper Countryman, Standard TransSECTION 61 13... Circular connector, 7-pin, 8-pin, system D2.5
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

Carefully pull off rubber grommet (1).

Carefully press back retaining tabs (2) of internal connector (3).

Fig 1: Pressing Back Retaining Tabs Of Internal Connector
G06894939Courtesy of BMW OF NORTH AMERICA, INC.

Slide internal connector (3) in direction of arrow until retaining tabs (2) lock into locking groove (4).

Fig 2: Sliding Internal Connector Until Retaining Tabs
G06894940Courtesy of BMW OF NORTH AMERICA, INC.

Use special tool 61 0 303 (61 1 132) to press back retaining hook (5) of corresponding contact and pull out cable with contact.

Fig 3: Pressing Back Retaining Hook Of Corresponding Contact
G06894941Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.