Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3985 (MAINTENANCE AND GENERAL INFORMATION - REPAIR)MAINTENANCE00 00... CHECKING COOLANT LEVEL AND CONCENTRATION, CORRECTING IF NECESSARY
2013 Mini Cooper Countryman, Standard Trans
00 00... Checking coolant level and concentration, correcting if necessary
2013 Mini Cooper Countryman, Standard TransSECTION 00 00... Checking coolant level and concentration, correcting if necessary
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Check connections, hose clamps and hoses for coolant residues and damage such as e.g. cracks.
- Check coolant composition in expansion tank: should be - 35 °C to - 40 °C.
- Check coolant level in expansion tank. Coolant level must be between the "Min." and "Max." marks. If necessary, top up coolant to max. fluid level. If there is no coolant, also identify the cause and notify the customer.
- During refill (for special allocation):
- If needed, drain COOLANT
- Top up PRESCRIBED COOLANT
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.