Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
33 11... Removing and installing/replacing vibration absorber
Vibration absorber to anti-roll bar, right:
Release screws (1).
Tightening torque 33 55 3AZ
Remove vibration absorber (2).
Installation note:
Replace screw.
Vibration absorber to rear axle differential, front right:
Slacken nut (1).
Tightening torque 33 17 3AZ
Remove vibration absorber (2).
Installation note:
Replace nut.
First, screw the rear axle differential to the rear axle support with the specified tightening torque.
Vibration absorber to rear axle differential:
Release screw (1).
Tightening torque 33 11 3AZ
Remove vibration absorber (2).
Vibration absorber to rear axle support, front:
Release screws (1).
Tightening torque 33 33 4AZ
Remove vibration absorber (2).
Vibration absorber to rear adapter:
Release screw (1).
Tightening torque 33 11 10AZ .
Remove vibration absorber (2).
Vibration absorber to front adapter:
Support rear axle differential.
Slacken nut (1).
Tightening torque 33 17 1AZ .
Remove screw and vibration absorber (2).
Installation note:
Replace nut (1) and screw.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.