Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
34 00... General Notes On Handling Carbon Ceramic Brakes (CSiC)
The brake system is one of the most important safety systems in the vehicle. Therefore, it is important to exercise special care when performing work on the brake system and to adhere to the following instructions.
Bear in mind that any kind of impact stress and collision with hard materials can damage ceramic surfaces and edges.
- Suitable training courses must be given in which employees are instructed accordingly
- To avoid damage to the brake disc and brake caliper, always use the wheel mounting lift to remove and fit wheels
- The carbon ceramic brake discs must not be reworked or modified.
- Retightening or removal of the connecting parts is not permitted.
- Damage to the hub contact surface and rim bearing surface is not permitted.
- Only a limited amount of spalling at the edges of the friction ring of the carbon ceramic brake disc is permitted. See ASSESSING CARBON CERAMIC BRAKE DISC FOR WEAR .
- Brake discs that have been exposed to heavy impact stress, e.g. have been dropped, must no longer be used. -> the brake disc is unserviceable due to visible and invisible damage!
- Wear measurement:
- Assessment of carbon ceramic brake discs.
See REFERENCE SAMPLE CATALOGUE for assessment of optical quality of new carbon ceramic brake discs.
- Only if required, clean the carbon ceramic brake disc with a high-pressure cleaner (observe relevant safety regulations).
- Brake cleaners must not be used
- If dirt contamination is lodged in the perforation holes, this can be pushed out carefully using a suitable tool (e.g. punch).
Do not machine the holes. Drilling or countersinking is not permitted!
See GENERAL INFORMATION ON BREAKING IN NEW BRAKE DISCS/BRAKE PADS .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.