Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3941 (STEERING AND WHEEL ALIGNMENT - REPAIR)STEERING COLUMN32 31... ELECTRICAL STEERING COLUMN ADJUSTMENT NORMALIZATION
2013 Mini Cooper Countryman, Standard Trans
32 31... Electrical Steering Column Adjustment Normalization
2013 Mini Cooper Countryman, Standard TransSECTION 32 31... Electrical Steering Column Adjustment Normalization
WARNING: This page does not describe the selected car, but rather 47 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Normalization must be carried out after the following work:
- Removal or replacement of control panel in heater-A/C system or of steering column.
- Repair work to electric steering column adjustment.
- Coding/programming of IHKA control unit.
Normalization of electric steering column adjustment is possible via the BMW diagnosis and information system under the following path:
- Diagnosis.
- Function selection.
- Service functions.
- Chassis.
- Electric steering column adjustment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.