Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
51 11... Installing/replacing license plate (without base)
Initial fitting:
Place drilling hole template (1) on bumper (2).
Drill holes according to license plate.
Remove template (1).
Secure license plate with screws provided.
Installation:
Tightening torque: see 7AZ in 51 11 FRONT BUMPER .
Fit protective caps.
Repairing thread:
Drill out defective hole in bumper (2) to 9.5 mm diameter.
Insert blind rivet nut (1).
Secure license plate (3) with license plate screw (M5 x 20).
Installation:
Tightening torque: see 8AZ in 51 11 FRONT BUMPER .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.