Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3903 (TRANSFER CASE - REPAIR)
2013 Mini Cooper Countryman, Standard Trans
Section 3903 (Transfer Case - Repair)
2013 Mini Cooper Countryman, Standard TransSECTION Section 3903 (Transfer Case - Repair)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2016 BMW 550i GT xDrive, 2016 BMW 535i GT xDrive, and 2015 BMW 550i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Transfer Case, General
- 27 00 270 Change transfer box oil (ATC 35L)
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 27 00... Replenishing/changing transfer case oil (ATC 350)
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety instructions for handling oil
- 27 00... Topping up transfer box oil (ATC 35L)
- Transfer Box
- 27 10 020 Installing exchange gearbox (ATC 350)
- 27 10 020 Installing exchange transfer box (ATC 35L)
- 27 10 010 Removing and installing transfer box (ATC 350)
- 27 10 010 Removing and installing transfer box (ATC 35L)
- 27 10 050 Replacing output flange for output to the front axle (ATC 350)
- 27 10 050 Replacing output flange for output to the front axle (ATC 35L)
- 27 10 070 Replacing output flange on rear transfer box (ATC 35L)
- 27 10 070 Replacing output flange on transfer box at rear (ATC350)
- 27 21 040 Replacing radial shaft seal for actuator shaft (ATC 350)
- 27 21 040 Replacing radial shaft seal for actuator shaft (ATC 35L)
- 27 10 730 Replacing transfer box control unit (longitudinal torque module) (ATC 350)
- 27 10 730 Replacing transfer box control unit (longitudinal torque module) (ATC 35L)
- Transmission Shafts
- 27 21 010 Renewing radial shaft seal for drive flange (ATC 35L)
- 27 10 070 Replacing output flange on rear transfer box (ATC 35L)
- 27 10 070 Replacing output flange on transfer box at rear (ATC350)
- 27 21 040 Replacing radial shaft seal for actuator shaft (ATC 350)
- 27 21 040 Replacing radial shaft seal for actuator shaft (ATC 35L)
- 27 21 010 Replacing radial shaft seal for drive flange (ATC 350)
- 27 21 020 Replacing radial shaft seal for output flange (ATC 350)
- 27 21 020 Replacing radial shaft seal for output flange (ATC 35L)
- 27 21 030 Replacing radial shaft seal for output to the front axle (ATC 350)
- 27 21 030 Replacing radial shaft seal for output to the front axle (ATC 35L)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.