Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
32 31 004 Removing and installing / replacing upper section of steering column trim
Necessary preliminary tasks:
- Remove lower section of trim .
- Move steering column into "lower" and "extended" position
Unclip steering column cover (1) from upper section of trim.
Unfasten screws.
Installation:
Replace expansion rivets.
Bend upper section of trim on both sides outwards and remove towards top.
Installation:
Lock (2) must engage in hooks (1) on both sides.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.