Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3899 (SLIDE/TILT ROOF - REPAIR)SUNROOF54 0... NOTES ON PANORAMA GLASS ROOF (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE)
2013 Mini Cooper Countryman, Standard Trans
54 0... Notes on panorama glass roof (initialization/normalization/learning of characteristic curve)
2013 Mini Cooper Countryman, Standard TransSECTION 54 0... Notes on panorama glass roof (initialization/normalization/learning of characteristic curve)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Initialization
comprises:
The mechanical end positions are recorded and stored during normalization.
The characteristic curve is learnt immediately after normalization.
When the characteristic curve is learnt, the mechanical closing forces of the panorama glass roof are recorded and stored for correct operation of the anti-trapping mechanism.
Initialization is started and implemented by pressing and holding switch in "Lift" direction.
Initialization depends on installed roof system and software used.
- Normalization
- Learning characteristic curve
The mechanical end positions are recorded and stored during normalization.
The characteristic curve is learnt immediately after normalization.
When the characteristic curve is learnt, the mechanical closing forces of the panorama glass roof are recorded and stored for correct operation of the anti-trapping mechanism.
Initialization is started and implemented by pressing and holding switch in "Lift" direction.
Initialization depends on installed roof system and software used.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.