Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3887 (GENERAL ELECTRICAL SYSTEM - REPAIR)WIRING HARNESS, REPAIR CABLE61 11... INSTALLING REPAIR CABLE FOR RIGHT SIDE VIEW CAMERA

2013 Mini Cooper Countryman, Standard Trans

61 11... Installing repair cable for right Side View camera

2013 Mini Cooper Countryman, Standard TransSECTION 61 11... Installing repair cable for right Side View camera

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Read and comply with notes on HANDLING WIRING HARNESSES AND WIRING .

NOTE: Work is shown on the F10 by way of example. There may be differences in detail in the case of other vehicle types and equipment specifications.

Necessary preliminary tasks:

Remove FRONT WHEEL ARCH COVER (FRONT SECTION) .
Remove HEATER/AIR CONDITIONER BLOWER .
REMOVE seal mounting for engine compartment lid.
REMOVE side trim panel from footwell on right A-pillar.
Perform the preliminary work as described in REMOVING THE TRSVC CONTROL UNIT ; but do not remove the TRSVC control unit.
REMOVE front seat on the driver's side.
Remove backrest side section on rear seat backrest.
Remove backrest.
Remove TRIM PANEL FOR REAR DOOR POST .

NOTE: Required preliminary may vary according to vehicle type and equipment.

Unlock the lock (1) in direction of arrow with suitable tool.

IMPORTANT: Risk of damage!

Unlock the lock (3) carefully with a suitable tool. Pull connector housing (4) of line (2) in direction of arrow.

Installation note:

Pay attention to encoding (5)!

Fig 1: Pulling Connector Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Connect repair cable (2) to Side View camera (1).

Lay repair cable (2) in direction of arrow along wiring harness (3) and secure at points marked with an arrow.

Fig 2: Locating Camera Repair Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Route repair cable (1) in direction of arrow along wiring harness (2) and attach at locations marked with arrow.

IMPORTANT: Risk of damage to wiring harness.
Carefully thread repair cable (1) through grommet (4).

After threading and securing repair cable (1), tape off grommet (4) at location (3) with suitable adhesive tape.

Fig 3: Locating Camera Repair Cable And Grommet

Courtesy of BMW OF NORTH AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.