SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3887 (GENERAL ELECTRICAL SYSTEM - REPAIR)PLUG CONNECTION, TERMINAL, POWER DISTRIBUTION BOX61 13... OPENING PLUG HOUSINGS AND REMOVING CONTACTS OF DIFFERENT PLUG SYSTEMS61 13... CIRCULAR CONNECTOR, 13-PIN, SYSTEM D2.5
2013 Mini Cooper Countryman, Standard Trans

61 13... Circular connector, 13-pin, system D2.5

2013 Mini Cooper Countryman, Standard TransSECTION 61 13... Circular connector, 13-pin, system D2.5
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

Pull off rubber grommet (1).

Carefully pull out lock (2) in direction of arrow.

Fig 1: Pulling Connector Lock
G08509595Courtesy of BMW OF NORTH AMERICA, INC.

Move lower section of connector (3) in direction of arrow until retaining lugs (4) snap into release groove (5).

Fig 2: Moving Connector Lower Section
G08509596Courtesy of BMW OF NORTH AMERICA, INC.

With special tool 61 0 303 , press down retaining lugs (6) of corresponding contact and pull out cable.

Fig 3: Pressing Down Retaining Lugs Using Special Tool (61 0 303)
G08509597Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.