Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3869 (REAR AXLE - REPAIR)
2013 Mini Cooper Countryman, Standard Trans
Section 3869 (Rear Axle - Repair)
2013 Mini Cooper Countryman, Standard TransSECTION Section 3869 (Rear Axle - Repair)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Safety Information
- General
- 33 00... Information on replacing shock absorbers
- 33 00... Instructions (chassis components made of aluminum)
- 33..... Overview of rear axle final drive/output shafts
- 33..... Overview of rear axle support with rubber mounts
- 33..... Overview of steering links
- 33..... Rear axle layout
- 33 00... Rear axle: wheel/chassis alignment check must be carried out after the following work
- 33... Grease for flange nut and drive flange
- Final Drive
- Final Drive With Cover
- 33 11... Removing and installing/replacing vibration absorber
- 33 11 271 Replacing cover gasket on rear axle final drive (205AL/225AL) at rear
- 33 11 021 Replacing radial shaft seal for drive flange on rear axle final drive (inserted propeller shaft)
- 33 11 271 Replacing rear cover gasket on rear axle final drive
- 33 11 151 Replacing shaft seal for drive flange left or right
- Final Drive Mounting
- Output Shafts
- Rear Sub-Frame
- Control Arms And Struts
- 33..... Overview of steering links
- 33 32 131 Removing and installing/replacing a steering stub/wheel carrier
- 33 32 153 Removing and installing/replacing front compression strut
- 33 32 064 Removing and installing/replacing left or right swinging arm
- 51 71 482 Removing and installing/replacing left or right tension strut (on rear axle)
- 33 32 180 Removing and installing/replacing left or right toe arm
- 51 71 015 Removing and installing/replacing left or right underbody panelling
- 33 32 240 Replacing ball joint in left or right swinging arm/wheel carrier
- 33 32 051 Replacing left or right push rod/integral link
- 33 32 071 Replacing one upper wishbone
- Axle Mounting
- Active Rear Axle Kinematics
- Wheel Bearings
- Shock Absorber
- Stabilizer Bar
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.