Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
63 11 800 Replacing left LED main light module left
Attention!
Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .
Necessary preliminary tasks:
- Remove HEADLIGHT
Release screws (1).
Tightening torque: see 1AZ in 63 11 INDIVIDUAL HEADLIGHT PARTS LED .
Remove LED main light module (2).
Installation note:
Gasket (1) for LED main light module (2) must not be damaged and must be installed free from grease.
Make sure LED main light module (2) is correctly installed.
Replacement:
Carry out PROGRAMMING/ENCODING .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.