Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3725 (SLIDE/TILT ROOF - REPAIR)MECHANICAL SUN ROOF COMPONENTS54 12... REPLACING COMPLETE LOWER FRAME SECTION
2013 Mini Cooper Countryman, Standard Trans
54 12... Replacing complete lower frame section
2013 Mini Cooper Countryman, Standard TransSECTION 54 12... Replacing complete lower frame section
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The spare part scope comprises the lower frame section without drives, sliding headlining and glass lid.
Necessary preliminary tasks:
- Remove GLASS SLIDE/TILT SUNROOF LID
- Remove SLIDING HEADLINING
- Remove HEADLINING
- Remove DRIVE UNITS WITH GEARING
- Remove GLASS SLIDE/TILT SUNROOF
Installation:
Follow the installation sequence from work steps 5 to 1.
After the operations are completed, the following tasks must be carried out:
- Adjusting GLASS SLIDE/TILT SUNROOF LID
- INITIALIZE glass slide/tilt sunroof
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.