Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
31 11 001 Replacing front axle support: Notes
In order to avoid damage to vehicle hoist, perform weight compensation on vehicle.
Load spring strut domes with sand bags.
Necessary preliminary tasks:
- Lower FRONT AXLE SUPPORT
- Remove BOTH LOWER WISHBONES FROM FRONT AXLE SUPPORT
- Remove BOTH TRAILING LINKS FROM FRONT AXLE SUPPORT
- Remove HYDRAULIC STEERING GEAR
Graphic shows: F01
Remove both engine mounts from front axle support
Take front axle support down and set down on a suitable surface.
Installation note:
Use previous front axle support as a template for modifying or replacing small parts.
Installation note:
Only on F01/02 vehicles with ARS:
Adapt holder of ARS hydraulic line if required.
Due to a modification on axle support (1), if necessary cut off tab (2) at the mark!
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.