Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 71... Procedure for replacing high-pressure lines
When replacing the H.P. lines, you must carry out a venting procedure after filling the fluid reservoir.
During the venting operation, a large amount of washer fluid may emerge from the spray nozzles. Have cleaning cloths at hand.
Call up service function "Vent headlight cleaning system" by way of DIS or MoDiC (refer to Diagnosis and Information System). In this case, the washer pump is activated for approx. 6 seconds and the H.P. lines are vented.
Top up washer fluid.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.