Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3712 (GENERAL ELECTRICAL SYSTEM - REPAIR)CONTROL UNITS, MODULES61 00... PROGRAM/ENCODE THE CONTROL UNIT(S)
2013 Mini Cooper Countryman, Standard Trans
61 00... Program/encode the control unit(s)
2013 Mini Cooper Countryman, Standard TransSECTION 61 00... Program/encode the control unit(s)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- In order to avoid incorrect programming procedures and fault messages, it is essential to always use the most current version when working with the ISTA/P programming system.
- Battery voltage must not drop below 13.0 V during programming. Connect battery charger prior to programming
Use only BMW-recommended battery chargers*
*Sourcing reference BMW Workshop Equipment Catalogue
IMPORTANT:
Prior to programming/encoding hybrid and electric vehicles disconnect the high-voltage system!
programming routine via ISTA/P:
- Connect the battery charger to the vehicle.
- Connect the programming system with the vehicle.
- Determine the action plan.
- Accept action plan with the control units to be programmed/encoded and enabled, if necessary or work through.
- Observe the reworking list!
- If applicable, connect the workshop system to the vehicle depending on the rework list, run the brief test and delete the fault memory.NOTE: A switch to the workshop system may not necessarily be required with the integration of the service functions and the "Delete fault memory" function in ISTA/P. Check the rework list accordingly!
- Compliance with the information about programming in workshop systems and the corresponding notes in the user documentation is required.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.