SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3673 (STEERING AND WHEEL ALIGNMENT - REPAIR)ELECTRONIC CHASSIS ALIGNMENT00 SAFETY INFORMATION FOR WORKING ON VEHICLES WITH AUTOMATIC ENGINE START-STOP FUNCTION (MSA)MSA FUNCTION IS DEACTIVATED BY
2013 Mini Cooper Countryman, Standard Trans

MSA function is deactivated by

2013 Mini Cooper Countryman, Standard TransSECTION MSA function is deactivated by
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
  • Deactivate MSA by means of button (1) in passenger compartment
  • Open seat belt buckle and driver's door
    Fig 1: Identifying MSA Button
    G08470364Courtesy of BMW OF NORTH AMERICA, INC.
  • Open engine bonnet/hood and ensure that engine hood/bonnet contact is not in workshop mode
    • Workshop mode

      A = 10 mm

    • Basic setting (engine hood/bonnet open)

      B = 7 mm

    Fig 2: Identifying Engine Hood/Bonnet Dimension (Basic Setting And Workshop Mode)
    G08470365Courtesy of BMW OF NORTH AMERICA, INC.

    To make sure that the engine hood/bonnet contact is at the basic setting, if necessary press the hood/bonnet contact up to the limit position before starting work and slowly release.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.