61 00... Notes on handling wiring harnesses and cables

2013 Mini Cooper Countryman, Standard TransSECTION 61 00... Notes on handling wiring harnesses and cables
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

The following applies in general: 

To avoid damage, observe the following instructions:

  • Avoid compressive and tensile loads
  • To ensure professional repairs, perform repair work only with BMW-approved or recommended special tools and spare parts
  • Make sure cables are laid without kinks or abrasions
  • Ensure non-contacting routing at sharp-edged body parts; use edge protection if necessary
  • Secure additionally laid cables/leads with cable ties

The following additionally applies 

Shielded cables 

Joins in the shield can cause problems with regard to noise radiation and interference immunity. Consequently, distinctions have to be drawn between the following types:

Coaxial cable 

  • Shielded RTK031 coaxial lines may only be repaired using special crimping tools.

CVBS cables 

  • CVBS cables may not be repaired.
  • CVBS cables must be replaced in their entirety.

HSD cables 

  • HSD cables may not be repaired.
  • HSD cables must be replaced in their entirety.

Fibre-optic cables: 

NOTE: Fibre-optic cables are colored differently as follows:
  • Green = MOST  ( edia riented ystems ransport) optical fibre
  • Yellow = ISIS  ( ntelligent afety ntegration ystem) optical fibres
  • Orange=repair fibre-optic cables
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.