Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3565 (ENGINE ELECTRICAL SYSTEM - SPECIAL TOOLS)ENGINE ELECTRICAL SYSTEM7200 TOOL

2013 Mini Cooper Countryman, Standard Trans

7200 Tool

2013 Mini Cooper Countryman, Standard TransSECTION 7200 Tool

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

0491180 127200 Tool MW

NOTE: (Tool set) For opening and closing the electronics box [discontinued]

Storage Location: J 106

Consisting of:

= 0491181 Pliers
NOTE: For bending the sheet metal tabs up [discontinued]
= 0491182 Lever
NOTE: For bending the sheet metal tabs up [discontinued]
= 0491183 Pliers
NOTE: For closing the sheet metal tabs [discontinued]
= 0491184 Socket wrench insert
NOTE: (Torx socket wrench insert T20) [discontinued]
= 0493403 Socket wrench insert
NOTE: (Torx socket wrench insert T10) [discontinued]
= 0493404 Pin
NOTE: (Fine line pen) Black, waterproof [discontinued]
= 0493405 Screwdriver
NOTE: (Screwdriver) [Discontinued]
= 0493406 Tool
NOTE: (Straightening tool) For Eprom connection [discontinued]

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.