Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3564 (ENGINE - SPECIAL TOOLS)ENGINE11-6110 TOOL SET

2013 Mini Cooper Countryman, Standard Trans

11-6110 Tool set

2013 Mini Cooper Countryman, Standard TransSECTION 11-6110 Tool set

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

0495274 116110 Tool set MW

NOTE: (Tool set) For removal and installation of gudgeon pin circlamps. [Released]

Storage Location: C52

SI number: 01 05 05 (180)

Fig 1: Identifying Tool Set (0495274)

Courtesy of BMW OF NORTH AMERICA, INC.

Consisting of:

= 0495275 Holder
NOTE: (Assembly holder) Not available individually, but as part of set 11 6 110 (0495274) only. [Not available separately]
= 0495276 Pliers
NOTE: (Assembly pliers) Not available individually, but as part of set 11 6 110 (0495274) only. [Not available separately]
= 0495277 Mandrel
NOTE: (Assembly mandrel) Remaining inventories will be sold off, followed by discontinuation and then not available individually, but as part of set 11 6 110 (0495274) only. [Not available separately]

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.