Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
63 11 820 Replacing left cornering light LED module
Necessary preliminary tasks
- Remove headlight See 63 12 140 REMOVING AND INSTALLING (REPLACING) LEFT HEADLIGHT WITH LED TECHNOLOGY or 63 12 143 REMOVING AND INSTALLING (REPLACING) RIGHT HEADLIGHT WITH LED TECHNOLOGY
Attention!
Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .
Release screws (1).
Tightening torque 63 11 3AZ .
Remove cornering light LED module (2).
Installation note:
Gasket (3) for cornering light LED module (2) must not be damaged and must be installed free from grease.
Mount corning light LED module (2) precisely on the headlight.
Make sure pin housing (4) is correctly seated in pin housing (5).
Replacement:
Carry out PROGRAMMING/ENCODING .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.