33 60 003 Removing and installing/replacing control unit for Dynamic Performance Control

2013 Mini Cooper Countryman, Standard TransSECTION 33 60 003 Removing and installing/replacing control unit for Dynamic Performance Control
WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Remove control unit only after being prompted to do so by diagnosis system.

Necessary preliminary tasks: 

Disconnect plug connection (1).

Release nuts (2) and remove control unit (3).

Installation note: 

Tightening torque 33 11 7AZ .

Fig 1: Identifying Plug Connection, Control Unit And Mounting Nuts
G08527897Courtesy of BMW OF NORTH AMERICA, INC.

Replacement 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.