Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3548 (SLIDE/TILT ROOF - REPAIR)ELECTRICAL SUN ROOF COMPONENTS54 0... NOTES ON PANORAMA GLASS ROOF (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE)INITIALIZATION PROCESS

2013 Mini Cooper Countryman, Standard Trans

Initialization process

2013 Mini Cooper Countryman, Standard TransSECTION Initialization process

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Move switch in "Lift" direction and hold (roof system moves to "Lift" position)
In the event of delayed starting or sudden stopping of the panorama glass roof, continue pressing the switch in the "Lift" direction

Fig 1: Locating Audio Unit Button
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Hold switch depressed for entire process.

After reaching the fully raised position (A), keep the switch pressed for approx. 30 seconds further (initialization process starts)

Fig 2: Lifting Panorama Glass Roof End Position
Courtesy of BMW OF NORTH AMERICA, INC.
Panorama glass roof moves briefly from lift end position (A) in direction of position (B)
Shading system (floating headlining) closes completely
Shading system (floating headlining) opens completely
Panorama glass roof moves to "Closed" position
Panorama glass roof then moves to "Open" end position and immediately back to "Closed" position
After a brief pause, shading system closes completely

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.