Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3536 (HEATING AND AIR CONDITIONING - REPAIR)COMPRESSOR64 52... INSTRUCTIONS FOR COMPRESSOR REPLACEMENT
2013 Mini Cooper Countryman, Standard Trans
64 52... Instructions for compressor replacement
2013 Mini Cooper Countryman, Standard TransSECTION 64 52... Instructions for compressor replacement
WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
IMPORTANT:
Risk of damage!
Remove the compressor without damaging and without the use of force!
Remove the compressor without damaging and without the use of force!
Compressors with plastic belt pulleys:
- Avoid impacts/knocks to plastic belt pulley (caused by tools, contact with base).
- Return faulty compressors in their original packaging only.
IMPORTANT:
When starting up a new compressor for the first time, it is absolutely essential to carry out the following breaking-in procedure:
- Switch off heating and air conditioning system
- Set all air vents in the dashboard to "OPEN"
- Start engine and let it stabilize at idle speed
- Set blower output to min. 75% of max. blower output
- Switch on Air conditioning system and run for at least 2 minutes at idle speed
.
Risk of damage at increased engine speed! .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.