Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 13... Rear repair wiring harness
Read and comply with notes on HANDLING WIRING HARNESSES and cables.
Installation note:
Use suitable TOOL FOR REPAIR WIRING HARNESS .
Necessary preliminary tasks:
- Remove SHOULDER IN LUGGAGE COMPARTMENT, RIGHT .
- Remove TRIM FOR REAR LID .
Release screws (1).
Remove battery cover (2).
Carry out wiring harness repair in area (1) according to wiring diagram.
If required, for reversing camera carry out wiring harness repair of shielded wiring in area (2) according to wiring diagram.
Route repair wiring harness (1) on tailgate and connect plug connections.
Installation note:
Make sure repair wiring harness (1) is routed without possibility of abrasions.
Lay repair wiring harness (1) on rear plate (2).
Installation note:
Make sure repair wiring harness (1) is routed without possibility of abrasions.
If require, repair plug connection (1) according to wiring diagram.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.