Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 34... Removing and installing/replacing socket in center console (rear)
Special tools required:
Pull lighter insert (1) out of socket.
Release retaining lugs (2) with special tool 00 9 317 and feed trim (3) in direction of arrow out of center console (4).
Disconnect plug connection (5) and remove trim (3).
Installation:
Retaining lugs (2) must not be damaged or missing.
Feed in trim (3) first at bottom into center console (4) and then press down at top.
Make sure trim (3) is correctly engaged on center console (4).
Release retaining lugs (1) with a suitable tool and press socket (2) in direction of arrow out of trim (3).
Installation:
Make sure socket (2) is correctly seated in trim (3).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.