Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 35 (ELECTRICAL COMPONENT LOCATOR)MISCELLANEOUS
2013 Mini Cooper Countryman, Standard Trans
Section 35 (Electrical Component Locator): Miscellaneous
2013 Mini Cooper Countryman, Standard TransSECTION Miscellaneous
WARNING: This page is about a different car, the 1999 BMW 318ti. However, it is still accessible from the selected car via links, so may be relevant.
MISCELLANEOUS
| Component | Component Location |
|---|---|
| Antenna Amplifier AM/FM | On liftgate. |
| Anti-Theft Horn (Alpine) | On right front side of engine compartment. |
| B+ Junction Point | On right side of engine compartment. |
| Blower Resistors | Behind center of dash. |
| Data Link Connector (DLC) | On left rear of engine compartment. See Figure . |
| Driver's Side Pyrotechnical Belt Tensioner | Right side of driver's seat. |
| HIFI Amplifier | On left side of luggage compartment. |
| Ignition Coil (Cyl. No. 1 - No. 4) | On right side of engine compartment, near shock tower. |
| OBD II Connector | Under left side of dash. |
| Passenger's Side Pyrotechnical Belt Tensioner | Left side of passenger's seat. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.