Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
32 31 092 Removing and installing/replacing steering column
Necessary preliminary tasks
- Disconnect BATTERY NEGATIVE LEAD .
- Remove steering wheel . See 32 33 000 REMOVING AND INSTALLING/REPLACING STEERING WHEEL or 32 33 010 REMOVING AND INSTALLING/REPLACING SPORT STEERING WHEEL .
- Remove steering column trims . See 32 31 020 REMOVING AND INSTALLING/REPLACING LOWER SECTION OF STEERING COLUMN TRIM or 32 31 003 REMOVING AND INSTALLING/REPLACING UPPER SECTION OF STEERING COLUMN TRIM .
- Move steering column into "extended" position.
- Replacement only: Remove STEERING-COLUMN SWITCH CLUSTER .
- Remove TRIM PANEL FOR PEDAL ASSEMBLY .
Disconnect plug connection (1).
Unclip wiring harness (2) from steering column.
Installation:
Replace damaged wiring harness holder.
Make sure wiring harness is in correct position.
Remove air duct in footwell.
Release clamping screw (1) and slide splined shaft (2) into steering column.
Installation:
Do not damage splined shaft (2).
Make sure shim (3) is in correct position.
Recut thread.
Replace clamping screw.
Clamping screw must rest in groove of upper steering spindle.
No subsequent buckling permitted!
Tightening torque 32 31 3AZ .
Disconnect plug connection (1).
Unfasten screws (2).
Tightening torque 32 31 1AZ .
Secure steering column against falling out.
Release screws (1).
Tightening torque 32 31 1AZ .
Remove steering column towards rear.
Installation:
When inserting steering column, make sure guide (1) is correctly fitted in instrument panel carrier.
After installation
- Carry out steering angle sensor adjustment/adjustment for active front steering . See 61 31 996 CARRYING OUT STEERING ANGLE SENSOR ADJUSTMENT or 32 10 005 ADJUSTMENT FOR ACTIVE FRONT STEERING .
- Carry out NORMALIZATION of electric steering column adjustment.
- Replacement only: Turn steering wheel in both directions to full lock. The airbag warning lamp must not light up in the process.
- Check directional stability of car
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.