Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3463 (TRANSFER CASE - REPAIR)
2013 Mini Cooper Countryman, Standard Trans
Section 3463 (Transfer Case - Repair)
2013 Mini Cooper Countryman, Standard TransSECTION Section 3463 (Transfer Case - Repair)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2014 BMW Alpina B7L xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Safety Information
- Transfer Case, General
- Transfer Case
- 27 10 020 Installing exchange transfer case (ATC 35L)
- 27 10 020 Installing exchange transfer case (ATC 350)
- 27 10 010 Removing and installing transfer box (ATC 35L)
- 27 10 010 Removing and installing transfer case (ATC 350)
- 27 10 050 Replacing output flange for output to the front axle (ATC 35L)
- 27 10 050 Replacing output flange for output to the front axle (ATC 350)
- 27 10 070 Replacing output flange on rear transfer box (ATC 35L)
- 27 10 070 Replacing output flange on transfer case at rear (ATC350)
- 27 21 040 Replacing radial shaft seal for actuator shaft (ATC 350)
- 27 10 730 Replacing transfer case control unit (longitudinal torque module) (ATC 350)
- Transmission Shafts
- 27 10 070 Replacing output flange on transfer case at rear (ATC350)
- 27 21 040 Replacing radial shaft seal for actuator shaft (ATC 35L)
- 27 21 040 Replacing radial shaft seal for actuator shaft (ATC 350)
- 27 21 010 Replacing radial shaft seal for drive flange (ATC 350)
- 27 21 020 Replacing radial shaft seal for output flange (ATC 35L)
- 27 21 020 Replacing radial shaft seal for output flange (ATC 350)
- 27 21 030 Replacing radial shaft seal for output to the front axle (ATC 35L)
- 27 21 030 Replacing radial shaft seal for output to the front axle (ATC 350)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.