Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3457 (ELECTRICAL DRIVES - REPAIR)DRIVE, POWER WINDOW67 62... NOTES ON INITIALIZING POWER WINDOWSOPERATING PROCEDURE FOR INITIALIZATION (MANUAL)PERFORMING INITIALIZATION
2013 Mini Cooper Countryman, Standard Trans
Performing initialization
2013 Mini Cooper Countryman, Standard TransSECTION Performing initialization
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Move side window to upper end position
- Pull and hold switch in "Close one-touch operation" (2nd switch position) during the entire process.
NOTE:
Re-initialization was successful if one-touch control function and anti-trapping protection function flawlessly.
Alternatively, initialization of the power window regulation can also be carried out via the Service function in BMW ISTA.
Selection via:
- Body
- Locking and security functions
- Power windows
- Initialize power windows
- Power windows
- Locking and security functions
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.