Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 31 008 Removing and installing steering column switch cluster
Do not under any circumstances turn the steering column switch cluster when the steering wheel is removed.
Necessary preliminary tasks
- Remove steering wheel . See 32 33 010 REMOVING AND INSTALLING/REPLACING SPORT STEERING WHEEL or 32 33 000 REMOVING AND INSTALLING/REPLACING STEERING WHEEL .
Unclip steering column shroud upper and lower sections (1).
Unfasten screws (2).
Tightening torque 61 31 3AZ .
Remove steering column switch cluster (3) in direction of arrow.
Installation note:
Not applicable to: F25
Carry out STEERING ANGLE SENSOR ADJUSTMENT .
On vehicles with active front steering, steering angle sensor adjustment is performed by means of START-UP / adjustment of active front steering.
Disconnect plug connection (1).
Remove steering column switch cluster (2).
Replacement:
Not applicable to F25.
- Carry out VEHICLE PROGRAMMING/ENCODING .
- Carry out STEERING ANGLE SENSOR ADJUSTMENT
- Vehicles with active steering:
- Steering angle sensor is adjusted by means of INITIAL OPERATION / ADJUSTMENT of active front steering.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.