SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3446 (GENERAL ELECTRICAL SYSTEM - REPAIR)PLUG CONNECTION, TERMINAL, FUSE BOX61 13... OPENING CONTACTS AND LOCKS OF DIFFERENT PLUG CONTACT SYSTEMS61 13... CIRCULAR CONNECTOR, 7-PIN, 8-PIN, SYSTEM D2.5
2013 Mini Cooper Countryman, Standard Trans

61 13... Circular connector, 7-pin, 8-pin, system D2.5

2013 Mini Cooper Countryman, Standard TransSECTION 61 13... Circular connector, 7-pin, 8-pin, system D2.5
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

Carefully pull off rubber grommet (1).

Carefully press back retaining tabs (2) of internal connector (3).

Fig 1: Pressing Back Retaining Tabs Of Internal Connector
G06911368Courtesy of BMW OF NORTH AMERICA, INC.

Slide internal connector (3) in direction of arrow until retaining tabs (2) lock into locking groove (4).

Fig 2: Sliding Internal Connector
G06894940Courtesy of BMW OF NORTH AMERICA, INC.

Use special tool 61 0 303 (61 1 132) to press back retaining hook (5) of corresponding contact and pull out cable with contact.

Fig 3: Pressing Back Retaining Hook Using Special Tool (61 0 303)
G06894941Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.