Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3391 (FRONT AXLE - SPECIAL TOOLS)FRONT AXLE31-1000 DEVICE

2013 Mini Cooper Countryman, Standard Trans

31-1000 Device

2013 Mini Cooper Countryman, Standard TransSECTION 31-1000 Device

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

0491850 311000 Device MW

NOTE: For removing and installing the rubber mount in the front axle support and in the wishbones and for press-fitting the taper roller bearing onto the differential case of the rear axle differential. [Discontinued]

Storage Location

Consisting of:

Fig 1: Identifying Device (0491850)

Courtesy of BMW OF NORTH AMERICA, INC.

= 0491851 Spindle
NOTE: With 2 nuts and 2 window glasses [discontinued]
= 0491852 Bush
NOTE: (Slip bush) For installing the rubber mount in the front axle support [discontinued]
= 0491853 Bush
NOTE: (Bush) For removing the rubber mount in the front axle support and for removing and installing the rubber mount in the wishbones and for press-fitting the taper roller bearing of the rear axle differential [discontinued]
= 0491854 Pipe
NOTE: (Support tube) For installing the rubber mount in the front axle support, series: E12 [discontinued]
= 0491855 Washer
NOTE: (Flanged washer) For centring of threaded spindle and as a support disc for removing and installing the rubber mount in the front axle support and in the wishbones, series: E12 [discontinued]
= 0491856 Synchronising key
NOTE: For removing and installing rubber mount in front axle support, series: E12 [discontinued]
= 0491857 Bush
NOTE: For installing the rubber mount in the front axle support, series: E12 [discontinued]
= 0491858 Bush
NOTE: (Bush) For installing the rubber mount in the front axle support and thrust piece, for removing and installing the rubber mount in the wishbones [discontinued]
= 0491859 Bush
NOTE: (Bush) Discontinued, only available via complete tool [cannot be ordered individually]

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.