Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
86 10... Removing shock absorber from overrunning equipment: Notes
Check the overrunning equipment shock absorber while installed to ascertain whether it needs to be replaced.
Apply handbrake. Push in and pull out tow ball end by hand. If it is very easy to pull out the tow ball end, the shock absorber must be replaced.
Release screw (1) and remove. Pull out internal shock absorber (2) from opening in tow tube (3) towards rear.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.