Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3109 (GENERAL ELECTRICAL SYSTEM - REPAIR - E90)CONTROL UNITS, MODULES61 00... VEHICLE PROGRAMMING AND ENCODING
2013 Mini Cooper Countryman, Standard Trans
61 00... Vehicle programming and encoding
2013 Mini Cooper Countryman, Standard TransSECTION 61 00... Vehicle programming and encoding
WARNING: This page is about a different car, the 2011 BMW M3, 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- In order to avoid incorrect programming procedures and error messages, it is essential when working with the Progman/ISTA/P programming system always to use the latest Progman version.
- Battery voltage must not drop below 13.0 V during programming.
Connect battery charger prior to programming.
IMPORTANT:
E72 only:
Before programming the vehicle, it is essential to disconnect the high-voltage system from the power supply.
Before programming the vehicle, it is essential to disconnect the high-voltage system from the power supply.
Programming sequence via ISTA/P:
- Identify vehicle and read out control unit data
- Draw up and configure measures plan
- Prepare programming, export CBS/CKM data
- Carry out repair measures, replace control units if necessary
- Identify vehicle again after repair. Update measures plan
- Carry out programming
- Assess programming afterwards, import CBS/CKM data
- Programming successfully completed
Programming sequence via Progman:
Select menu item (1).
Select corresponding procedure from selection list.
For example:
- Preparation and subsequent evaluation of vehicle programming
- Start a Progman session
- Sequence of BMW/MINI vehicle programming and encoding
- BMW/MINI Car & Key Memory
- BMW/MINI initialization
- BMW/MINI service functions in Progman
- ...
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.