Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 31 (ELECTRICAL COMPONENT LOCATOR)MOTORS
2013 Mini Cooper Countryman, Standard Trans
Section 31 (Electrical Component Locator): Motors
2013 Mini Cooper Countryman, Standard TransSECTION Motors
WARNING: This page is about a different car, the 1997 BMW Z3. However, it is still accessible from the selected car via links, so may be relevant.
MOTORS
| Component | Component Location |
|---|---|
| Auxiliary Fan Motor | Behind front grille. |
| Auxiliary Throttle Position Motor (ADS) | Front of engine. |
| Blower Motor | Rear of engine compartment, behind right fresh air cowl. |
| Cruise Control Actuator | Rear left side of engine compartment. |
| E-Box Fan | Right rear side of engine compartment, in E-box. |
| Fresh Air Recirculation Motor | Right side of left footwell. |
| Fuel Pump | In fuel tank. |
| Trunk Lock Motor | Rear side of luggage compartment. |
| Washer Pump | Front right side of engine compartment, on washer fluid reservoir. |
| Washer Pump (Headlamp/Fog Lamp) | Front right side of engine compartment, on washer fluid reservoir. |
| Wiper Motor | Rear of engine compartment. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.