Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3015 (TRAILERS - REPAIR - E90)8621 HOOD8621... REPLACING INSIDE LIGHT POWER CABLEINSTALLATION

2013 Mini Cooper Countryman, Standard Trans

8621... Replacing inside light power cable: Installation

2013 Mini Cooper Countryman, Standard TransSECTION Installation

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Carefully remove traces of old adhesive with a scraper. Use standard heat gun adhesive as adhesive.

Fig 1: Identifying Power Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully remove adhesive bonds of power cable (1) from hood surface.

Carefully remove traces of old adhesive with a scraper. Use standard heat gun adhesive as adhesive.

Fig 1: Identifying Power Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Remove flat connectors (1). Strip cable ends (2) and connect to a new cable. Feed cable connection through opening (3).

Fig 2: Identifying Flat Connectors, Strip Cable Ends And Feed Cable Connection Opening

Courtesy of BMW OF NORTH AMERICA, INC.

Lay new power cable with old power cable through duct (1).

Fig 3: Identifying Power Cable Duct

Courtesy of BMW OF NORTH AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.