SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 30 (BRAKES - REPAIR)TESTINGPARKING BRAKE
2013 Mini Cooper Countryman, Standard Trans

Parking Brake

2013 Mini Cooper Countryman, Standard TransSECTION Parking Brake
WARNING: This page does not describe the selected car, but rather 92 other vehicles, including the 2002 BMW Z3, 2002 BMW M Roadster, 2002 BMW M Coupe, 2001 BMW Z3, and 2001 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This test may set the ABS and ASC warning lights on the instrument cluster. The lights are illuminated because the system sees an implausible speed differential between the spinning rear wheels, and the stationary front wheels. Vehicles equipped with DSC3 will not set the lights.

On 735i and 745i vehicles connect BMW Diagnosis and Information System (DIS) or MoDiC. Call up "Workshop braking-in" service function and start braking-in program.

Parking brake must be tested on roller dynamometer as follows:

  1. With parking brake released wheel circumferential force is no more than 300 N.
  2. At the first tooth, do not allow braking force to increase.
  3. At the 2nd tooth, braking action can begin and the indicator light may be lit.
  4. At the 3rd, tooth, braking action must begin and the indicator light must be lit.
  5. At the 4th tooth, braking action increases.
  6. At the 5th tooth, wheel circumferential force must be at least 1100 N at one of the two rear wheels, and at least 1000 N at the other wheel. Wheel circumferential force differential (left to right) maximum 30% from highest value (shortly before wheel lockup). A readjustment must be carried out in event of larger deviations of wheel circumferential force. See PARKING BRAKE  under ADJUSTMENTS.
  7. Braking with locked wheels must be possible with the parking brake.
  8. The ABS/ASC warning lights, if on, will automatically switch off by switching off engine, waiting at least 30 seconds, restart engine and drive away. Warning lights will go out when speed exceeds 8 mph. (Fault codes will be retained in memory.)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.