Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2848 (MAINTENANCE AND GENERAL INFORMATION - REPAIR)MAINTENANCE AND GENERAL DATA00 00... DIAGNOSTIC BRIEF TEST
2013 Mini Cooper Countryman, Standard Trans
00 00... Diagnostic brief test
2013 Mini Cooper Countryman, Standard TransSECTION 00 00... Diagnostic brief test
WARNING: This page is about a different car, the 2010 BMW 650i, 2009 BMW 650i, and 2008 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.
Connect diagnostic system to OBD socket.
Switch on ignition.
Carry out vehicle identification.
Click on Brief test.
The brief test is carried out.
NOTE:
For motor vehicle diagnostics, the brief test is essential for evaluating possible stored diagnostic trouble codes. In the brief test, the control units are physically identified in succession and their fault memories read out.
If the fault memory has been read out, the faults appear in the "Fault pattern selection" mask in the "Fault memory contents" field.
Check identified faults and if necessary rectify these faults after consulting with customer.
If the fault memory has been read out, the faults appear in the "Fault pattern selection" mask in the "Fault memory contents" field.
Check identified faults and if necessary rectify these faults after consulting with customer.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.