SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2494 (TRAILERS - REPAIR)LOADING PLATFORM86 10... REPLACING DRAWBAR MEMBERS, LEFT AND RIGHTINSTALLATION
2013 Mini Cooper Countryman, Standard Trans

86 10... Replacing drawbar members, left and right: Installation

2013 Mini Cooper Countryman, Standard TransSECTION Installation
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Tightening Torque,

refer to 86 10 16AZ, see 86 10 PLATFORM .

Fig 1: Identifying Screws On Cross-Member
G04766422Courtesy of BMW OF NORTH AMERICA, INC.

Release countersunk head screws (1) and remove.

Fig 2: Identifying Countersunk Head Screws
G04766423Courtesy of BMW OF NORTH AMERICA, INC.


Tightening Torque,

refer to 86 10 3AZ, see 86 10 PLATFORM .

Remove cable holder (1) and remove wiring harness (2) from drawbar member (3).

Fig 1: Identifying Cable Holder, Wiring Harness And Drawbar Member
G04766424Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable (1) from position light housing (2). Pull out cable (1) through drawbar member aperture (3).

Fig 2: Identifying Position Light Housing And Cable
G04773416Courtesy of BMW OF NORTH AMERICA, INC.

Release all screws on cross-member (1) and remove crossmember (1).

If necessary, release screws on mounting brackets (2) and remove cross-members (3).



Use new self-locking nuts.

Tightening Torque,

refer to 86 10 17AZ, see 86 10 PLATFORM .

Fig 1: Identifying Screws On Mounting Brackets And Cross-Members
G04766426Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolt (1). Grip nut from rear through assembly hole (2) in cross-member.

Fig 2: Identifying Hole And Bolt
G04766427Courtesy of BMW OF NORTH AMERICA, INC.


Use new self-locking nuts.

Tightening Torque,

refer to 86 10 18AZ, see 86 10 PLATFORM .

Tilt drawbar member (1) down in direction of arrow A and pull out towards rear in direction of arrow B.

Fig 1: Tilt Drawbar Member (1) Down In Direction Of Arrow
G04786737Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.