Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
86 21... Replacing inside light power cable: Installation
Carefully remove traces of old adhesive with a scraper.
Use standard heat gun adhesive as adhesive.
Carefully remove adhesive bonds of power cable (1) from hood surface.
Carefully remove traces of old adhesive with a scraper. Use standard heat gun adhesive as adhesive.
Remove flat connectors (1). Strip cable ends (2) and connect to a new cable. Feed cable connection through opening (3).
Lay new power cable with old power cable through duct (1).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.