Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2452 (FUEL SYSTEM - REPAIR (N63))SENSOR FOR CONTROL UNIT13 62 593 REMOVING AND INSTALLING/REPLACING PRESSURE SENSOR ON LEFT INTAKE MANIFOLD (N63)
2013 Mini Cooper Countryman, Standard Trans
13 62 593 Removing And Installing/Replacing Pressure Sensor On Left Intake Manifold (N63)
2013 Mini Cooper Countryman, Standard TransSECTION 13 62 593 Removing And Installing/Replacing Pressure Sensor On Left Intake Manifold (N63)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Read out fault memory of DME control unit.
- Switch off ignition
- Remove coolant expansion tank . See 17 11 100 REMOVING AND INSTALLING/REPLACING COOLANT EXPANSION TANK (N63) .
Unlock plug (1) and remove.
Release screws (2).
Tightening torque, see 13 62 2AZ in SENSOR FOR CONTROL UNIT .
Pull pressure sensor (3) out of left intake manifold.
Installation:
Now clear the fault memory.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.