SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2442 (CONVERTIBLE TOP - REPAIR)MOTOR OPERATED CONVERTIBLE TOP54 34... REPAIR INSTRUCTIONS FOR CONVERTIBLE TOP HYDRAULIC SYSTEMDEFINITIONS OF TERMS
2013 Mini Cooper Countryman, Standard Trans

Definitions Of Terms

2013 Mini Cooper Countryman, Standard TransSECTION Definitions Of Terms
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
INSTRUCTIONS TABLE

Depressurized hydraulic system or released state:
  • Turn ignition lock to "0" position.
  • System rendered depressurized after 10 minutes
 Hydraulic system has no or only very low pressure
Emergency actuation:
  • Convertible top is opened or closed by hand
  • Always move convertible top with aid of a second person
 Observe Point 3
Closed system:
  • All lines are connected
 No "short circuit" of leads possible
> No quick-connect couplings
Function test:
  • Open and close convertible top several times (min. 3 times)
  • Check fluid level in hydraulic unit; if necessary, top up fluid
 Refer to brief instruction 54 34 001 Checking Function Of EH Convertible Top 
Function test:
  • Checking of convertible top function if possible on removed convertible top
 Convertible top must be secured!
Move 2-3 times
Convertible top stowed:
  • Convertible top fully open (folded together)
 When the convertible top is installed, it is in the closed convertible top compartment
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.