Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2422 (ENGINE ELECTRICAL SYSTEM - REPAIR)ELECTRONIC SWITCHING12 14 700 CODING CONTROL MODULE (DME/DDE)
2013 Mini Cooper Countryman, Standard Trans
12 14 700 Coding control module (DME/DDE)
2013 Mini Cooper Countryman, Standard TransSECTION 12 14 700 Coding control module (DME/DDE)
WARNING: This page is about a different car, the 2010 BMW 135i, 2009 BMW 135i, and 2008 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.
Switch off ignition.
Connect MoDiC or DIS/GT1 Tester.
Switch on ignition.
Select "Coding" program.
For subsequent procedure, follow instructions in MoDiC or DIS/GT1 Tester.
Carry out adjustment of following control units:
- EWS (electronic immobilizer)
- DME (Digital Motor Electronics) or
- DDE (Digital Diesel Electronics)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.