61 35 115 Removing And Installing/Replacing Footwell Module

2013 Mini Cooper Countryman, Standard TransSECTION 61 35 115 Removing And Installing/Replacing Footwell Module
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection)   .

Necessary preliminary tasks: 

Disconnect plug connection (1).

Release nuts (2) and remove footwell module (3).

Fig 1: Identifying Footwell Module & Plug Connection
G04727640Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Carry out vehicle programming/coding  .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.