Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 234 (ELECTRICAL COMPONENT LOCATOR)CONTROL UNITS
2013 Mini Cooper Countryman, Standard Trans
Control Units
2013 Mini Cooper Countryman, Standard TransSECTION Control Units
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2001 BMW 750iL, 2001 BMW 740iL, 2001 BMW 740i, 2000 BMW 750iL, and 2000 BMW 740iL. However, it is still accessible from the selected car via links, so may be relevant.
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| ABS/ASC Control Module (A52) | Right side of engine compartment. See Figure. |
| ABS/DSC Control Module (A65) | Right side of engine compartment. See Figure. |
| Driver's Door Module (A23) | Left front door. See Figure. |
| General Module (A1) | Behind glove box. See Figure. |
| Light Module (A3) | Right kick panel. See Figure. |
| Navigation Control Module (A112) | Left side of luggage compartment. See Figure. |
| Passenger's Door Module (A24) | Right front door. See Figure. |
| Sun Blind Control Module (A82) | Below right side of rear seat. See Figure. |
| Sunroof Module (A33) | Front of roof. See Figure. |
| Supplemental Restraint System Control Module (A12) | Below center console. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.