Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
33 17... Replacing rubber mount
Special tools required:
- 33 4 281
- 33 4 282
- 33 4 283
- 33 4 284
- 33 4 465
- 33 4 466
Withdrawing rubber mount: Pull out rubber mount with special tools 33 4 282, 33 4 281, 33 4 466, 33 4 465 and nut (1).
Installing rubber mount: Important! Coat bearing bush in rear axle support and new rubber mount with Circo Light. Align rubber mount by way of elongated hole (1) to vehicle transversal direction.
Insert rubber mount (1) in special tool 33 4 283. Align rubber mount (1) by way of elongated hole to vehicle transversal direction. Draw in rubber mount (1) with special tools 33 4 282, 33 4 283, 33 4 284, 33 4 466 33 4 465 2and as far as it will go.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.